A Tilta set: a charging station for LP-E6P batteries and four batteries (Tilta LP-E6P, 2 400 mAh). The station runs off USB-C, draws up to 45 W and charges four batteries in about three hours; a status indicator sits above each slot. The batteries have their own USB-C input and a decoding chip, so the camera reports the charge level and raises no unapproved-battery…
A Tilta set: a charging station for LP-E6P batteries and four batteries (Tilta LP-E6P, 2 400 mAh). The station runs off USB-C, draws up to 45 W and charges four batteries in about three hours; a status indicator sits above each slot. The batteries have their own USB-C input and a decoding chip, so the camera reports the charge level and raises no unapproved-battery warning. Colour: Off White.
Besides the charging unit, this set contains four batteries (Tilta LP-E6P, 2 400 mAh) and a USB-C cable. Every battery has its own USB-C input, so it can be topped up without the station, and a decoding chip makes sure the camera reports the charge level and raises no unapproved-battery warning. On one charge it lasts 529 stills or two hours of video, according to the manufacturer.

The station is powered over USB-C and draws up to 45 W. That charges four LP-E6 batteries in about three hours — 68 % faster than a charger with a single slot, according to the manufacturer. Full speed needs a 45 W or stronger PD power source and a cable rated for it; a weaker source still works, it just takes longer. The input accepts 9 V/3 A, 12 V/3 A and 15 V/3 A.
Four status indicators sit above the slots, one for each position. Green means 80–100 % charge, amber 30–80 % and red below 30 %. When you insert a battery the indicators show its level and go out after about five seconds, so the station does not glow away inside your bag.
In sleep mode the station's own draw falls to as little as 0.1 mA, so batteries left in the station do not quietly run flat and need not be topped up again before a trip. Even so, the manufacturer advises against leaving the station unused for more than three months.
The station holds four LP-E6 batteries at once and charges them simultaneously, drawing up to 45 W in total. It doubles as a case — the batteries clip into one block instead of rattling around the bag. Four full batteries are good for more than 13 hours of video or about 2,400 stills, according to the manufacturer.
The body is moulded from PC + ABS with a matte finish in Tilta's signature style. The station measures 122 × 57 × 77 mm and weighs 171 grams, so it slips into the side pocket of a bag without adding noticeable weight. It has no internal battery — it charges only while connected to an external power source.
According to the manufacturer the station takes Canon LP-E6 batteries, Tilta batteries and most third-party LP-E6 batteries. The Tilta LP-E6P (2,400 mAh) that Tilta sells together with this station fits it as well.
Canon lists the LP-E6P battery for these bodies:
EOS R5 Mark II · EOS R6 Mark III · EOS R6 Mark II · EOS R6 V · EOS R6 · EOS R5 · EOS R7 · EOS R · EOS Ra · EOS C50 · EOS 90D · EOS 80D · EOS 70D · EOS 60D · EOS 60Da · EOS 7D Mark II · EOS 7D · EOS 6D Mark II · EOS 6D · EOS 5D Mark IV · EOS 5DS R · EOS 5D Mark III · EOS 5D Mark II
Canon states that the LP-E6P is compatible with all cameras powered by LP-E6 series batteries.
Source: Canon UK, verified 9 September 2026.
| Manufacturer: | Tilta |
| Category: | 7.2V chargers |
| Charging slots | 4ks |
| Charger battery type | LP-E6 |
A competitively priced set for intermediate filmmakers.
read morelessSpecial offers and discounts for subscribers only · Free audio & video workshops · News and tips from the world of filmmaking