Tilta Accessory Mounting Clamp - Black

The Tilta Accessory Mounting Clamp is an aluminium clamp that grips anything round or square between 13 and 30 mm thick — a tripod leg, a gimbal ring, a railing or a shutter. Silicone inserts hold without slipping and will not scratch paint; the load rating is 3 kg. Out of the body run 1/4"-20 and 3/8"-16 threads with locating points for a monitor, a light, a microphone or an articulating arm.

The Tilta Accessory Mounting Clamp answers the places where there is no thread at all. The jaws open to 30 mm and close to 13 mm, so the clamp grips a tripod tube, a gimbal ring, a window frame or the edge of a board — and from there the thread leads wherever it is needed.

Grip range 13 to 30 mm

The jaws open to 30 mm and tighten down to 13 mm. That covers tripod tubes, gimbal rings, door frames and the edges of a table board — the clamp is not limited to round profiles.

Silicone inserts, 3 kg load

The jaws are lined with silicone: nothing slips even in motion, and a painted or carbon profile is left unmarked. The manufacturer gives the clamp a 3 kg load rating.

1/4"-20 and 3/8"-16 threads

Both common thread sizes sit on the body, each with locating points against rotation. A monitor, an LED light, a wireless video transmitter, a microphone or a small battery plate all screw straight on.

Aluminium, 111 g, 70 × 58 × 23 mm

The body is aluminium alloy with a stainless steel screw and weighs 111 g. It takes less bag space than a lens and barely registers against a gimbal payload limit.