Tilta 2-Pin Lemo to 2-Pin Lemo Cable (Right Angle)

The Tilta TCB-2LE-2LE-20 is a short power cable with a 2-pin Lemo plug at both ends, both connectors right-angled. It links two 2-pin Lemo devices that sit close together on the rig — the power output on the cage or battery plate and the input of a monitor, transmitter or gimbal power plate — without a loop of cable getting in the way.

The Tilta TCB-2LE-2LE-20 is the short version of the 2-pin Lemo to 2-pin Lemo cable with right-angle connectors. Where source and accessory are only a few centimetres apart it replaces a long cable with a loop, and the accessory runs off the same battery as the camera.

Right-angle 2-pin Lemo at both ends

Both connectors are 2-pin Lemo with push-pull locking and a right-angle exit: the cable leaves the connector along the wall of the device rather than straight out, so it does not stick out of the cage and neither a hand nor a strap catches on it. One end goes into the 2-pin Lemo output on the cage, battery plate or splitter, the other into the 2-pin Lemo input of the accessory. The cable does not change the voltage, it only carries it: source and accessory must work at the same voltage.

Short cable, no loop

The short length is for devices sitting side by side on the rig — the cage power module and a monitor on the top handle, the battery plate and a transmitter at the back. The longer straight version with straight connectors is the TCB-2LE-2LE-17.

Tilta cables

The Tilta TCB cable range links camera, battery and accessories on the rig: power from a V-Mount or Gold Mount plate over P-Tap, 2-pin Lemo, 3-pin Fischer or a DC barrel connector, USB-C PD for monitors and handles, 7-pin control cables for the Nucleus system and HDMI or BNC for the picture. Lengths follow the rig — short on the cage, longer out to arms and batteries; this cable is one of them.