Tilta 2-Pin Lemo to 2-Pin Lemo Cable

The Tilta TCB-2LE-2LE-17 is a power cable with a 2-pin Lemo plug at both ends. It plugs into a 2-pin Lemo power output on the rig — on a battery plate, a splitter or the cage — and carries power to accessories with a 2-pin Lemo input: a monitor, a video transmitter, a light or a gimbal power plate. Straight copper cable with a rubber jacket and aluminium-alloy connectors.

The Tilta TCB-2LE-2LE-17 links two devices with a 2-pin Lemo connector. The accessory then runs off the same battery as the camera and the rig needs no second battery — the setup stays small and there is only one battery to swap.

2-pin Lemo at both ends

Both ends of the cable carry a 2-pin Lemo plug with push-pull locking, so the connector will not pull out even when the cable is tugged. One end goes into the 2-pin Lemo output on a battery plate, splitter or cage power module, the other into the 2-pin Lemo input of the accessory — a monitor, video transmitter, light or gimbal power plate. The cable does not change the voltage, it only passes it on: source and accessory must work at the same voltage.

Straight copper cable

The cable is straight, with copper conductors, a rubber jacket and aluminium-alloy connectors. On the cage it runs along the rods or the edge of the cage, and a hook-and-loop strap gathers the spare length. The colour is black so it does not draw attention on the rig.

The same cable is also made in a short version with right-angle connectors (TCB-2LE-2LE-20) for devices sitting close together.

Tilta cables

The Tilta TCB cable range links camera, battery and accessories on the rig: power from a V-Mount or Gold Mount plate over P-Tap, 2-pin Lemo, 3-pin Fischer or a DC barrel connector, USB-C PD for monitors and handles, 7-pin control cables for the Nucleus system and HDMI or BNC for the picture. Lengths follow the rig — short on the cage, longer out to arms and batteries; this cable is one of them.