Panasonic AU-EVA1 Firmware 1.10

Panasonic released a new firmware update for its AU-EVA1 digital cinema camera. The updated contains several fixes for HDMI output, Focus Assist, or Wi-Fi communication. To install, copy the downloaded update file to an SD memory card, and follow the installation procedure.

Panasonic AU-EVA1 1.10 improvements

• When the HDMI output is connected to BT-LH1850 monitor and displayed on it, once the monitor’s input setting is switched to SDI, "No Signal" is shown and no image will be displayed any more even if the setting is put back to HDMI. This problem is fixed.
• Display of SENSOR TEMP at low temperatures is improved.
• Panning at high speed may cause ghosting. This problem is fixed.
• Focus Assists are not displayed on the SDI output destination when the LCD panel is disconnected. This problem is fixed.
• An image on the LCD is defective when Open Iris F. A. is enabled. This problem is fixed.
• Error in information superimposed on SDI (payload) at 24.00 Hz is corrected to 60.00.
• Even if the Wi-Fi setting is switched from INFRA to DIRECT, the display of IP address will not change. This problem is fixed.
• The camera cannot connect to Wi-Fi using D-Link DWA-171 (For Australian Market). This problem is fixed.