Tilta Protective Travel Case for Osmo Pocket 4 - Black

A Tilta protective travel case for the DJI Osmo Pocket 4 in black. It is moulded specifically for the Pocket 4 and does not fit the Osmo Pocket 3. The camera sits inside completely: the shell takes the knocks, the flocked velvet lining keeps scratches away. Three magnetic filter slots are built in, and the third one also takes a wide-angle lens. It weighs 71.5 g and has anchor points for a shoulder strap, a lanyard or a wrist strap.

Three magnetic filter slots

There are three magnetic slots in the lid and body of the case. Two hold filters, the third also takes a wide-angle lens. Your filters no longer rattle around in the bag or rub against each other, and you pull one out in a single move.

Velvet lining inside

The inside is flocked — a short velvet pile that rests against the camera body, holds it in place and cannot scratch it. Screen and lens never rub against hard plastic, even when the case travels in a bag with your keys.

A latch that will not pinch

The lid closes with a snap latch you can open with one thumb, with nothing that could pinch a finger. You hear it close, so you know the camera is secured even without looking.

Four ways to carry it

The case has several attachment points: a shoulder strap (adjustable from 120 to 160 cm), a neck lanyard or a wrist strap all clip on. The camera stays within reach and there is no risk of dropping it. The manufacturer does not list a strap in the packing list.

Four colours

The case comes in four colours: black, lime green, light pink and sky blue. The matte finish does not hold fingerprints or oily smears, so even the light colours still look clean after weeks in a bag.

Just 71.5 grams

The whole case weighs 71.5 g — about as much as two AA batteries added to the camera. Around your neck or over your shoulder you soon forget it is there, while the camera and its filters stay together and protected.

For the Osmo Pocket 4 only

The case is moulded specifically for the DJI Osmo Pocket 4. The Osmo Pocket 3 has a different body shape and a different control layout, so it does not belong in this case — please check which model you own before ordering.