Tilta ND Filter Kit for DJI Osmo Pocket 3/4

A set of four fixed Tilta ND filters — densities 1.5 / 1.8 / 2.1 / 2.4, that is 5, 6, 7 and 8 stops (ND32 to ND256). All the filters mount magnetically and are thin enough not to block lens retraction or gimbal calibration. They fit both the DJI Osmo Pocket 3 and the Osmo Pocket 4.

Four densities in one kit

The kit holds four fixed ND filters: 1.5 (ND32, 5 stops), 1.8 (ND64, 6 stops), 2.1 (ND128, 7 stops) and 2.4 (ND256, 8 stops). Between them they cover everything from an overcast afternoon to snow and sea at noon. There is no diffusion or polarizing filter in this kit — those are in the Ultimate kit.

Magnetic mount

The filter attaches to the Osmo Pocket lens magnetically. Just hold it close, it snaps into the right position and stays there. No threading, no adapter — swapping filters takes a couple of seconds even in the field, with gloves on or on the move.

Off with two fingers

The filter frame has finger grooves along the top and bottom edge. You pinch it off with two fingers without touching the glass — no need to put the camera down or switch it off.

No interference with lens retraction

The filter is thin enough not to interfere with lens retraction or gimbal calibration. You can fold the camera up and put it away with the filter on; next time you switch it on, it levels itself as if nothing were fitted.

Optical glass, coated on both sides

The glass is optical grade, ground to keep the image sharp and the colours true. A double-sided coating repels water and oil and protects against scratches, so the filter doubles as lens protection.

For Osmo Pocket 3 and Osmo Pocket 4

Tilta makes this filter line for both the DJI Osmo Pocket 3 and the DJI Osmo Pocket 4 — the two cameras share the same mount, so the filter fits either. It does not fit the older Osmo Pocket or the Pocket 2.