Tilta NP-W235 Battery with USB-C Input (2400mAh) for Fujifilm Cameras – Green

The Tilta NP-W235 replacement battery charges straight from a cable through its own USB-C input — no charger and no dock required. The cell delivers 2400 mAh, that is 17.28 Wh at a nominal voltage of 7.2 V, and a full charge takes about 2.5 hours. Its dimensions match the original, so it fits the camera without any adapter. Green finish.

The Tilta NP-W235 is a replacement battery for Fujifilm cameras that take the original NP-W235 cell. Its size and shape match the original, so it drops into the battery compartment without play and without adapters. The difference is the USB-C input on the battery itself: it charges from an ordinary cable off a power bank, a laptop or a mains adapter, so there is no charger to pack. The input handles 5 V / 2 A (10 W) and a full charge takes roughly 2.5 hours.

Inside sits a decoding chip that passes battery data to the body. The camera therefore shows the state of charge as a percentage exactly as with the original and raises no unrecognised-battery message. The 2400 mAh capacity is higher than that of the original cell; measured by Tilta to the CIPA standard, the battery delivers 414 stills or 83 minutes of video on a single charge.

The housing is PC + ABS and the battery carries multi-stage protection — against overcharge, deep discharge, short circuit, overcurrent, overheating and magnetic fields. The CCC, FCC, CE, PSE, KC, UL, BSMI certifications cover safety requirements for the European and overseas markets. Operating temperature is −20 to 60 °C, so the battery works in frost and in heat alike.

According to the camera manufacturer, the NP-W235 cell is intended for X-T4, X-T5, X-S20, X-H2, X-H2S, GFX100S, GFX100S II, GFX100 II, GFX100RF, GFX50S II, GFX ETERNA 55. Check the cell type for your particular body in its manual; the list changes with new models.