Ulanzi SC-02 Strong Suction Cup Mount 4.5″

The Ulanzi SC‑02 is a rugged 4.5″ vacuum suction cup with a hand pump, a double-ball joint, and a NATO quick-release rail for securely mounting an action camera or lightweight camera on clean, flat, and non-porous surfaces. It offers 360° adjustment, standard 1/4″–20 and 3/8″–16 threads, and a recommended load capacity of up to 3 kg for static use.

Strong vacuum suction cup with pump

The Ulanzi SC-02 has a 114 mm suction cup with a hand pump, a dual ball-joint arm and a NATO rail. It mounts an action camera or a light camera on a clean, flat, non-porous surface.

114 mm suction cupHand pump3 kg load (static)NATO rail + 360° arm1/4" and 3/8" threads

A camera where a tripod will not work

On glass, car bodies, metal panels and other smooth surfaces. Recommended load is up to 3 kg for static use and significantly less while driving.

Glass and bodywork

Shots through glass, low angles.

Time-lapse

Static shots on a smooth surface.

Action cameras

1/4"-20 screw on the arm.

Travel

The whole set in a bag.

Pump, arm and up to 3 kg

The hand pump removes the air under the suction cup and the dual ball-joint arm sets to the angle you want. Recommended load is 3 kg for static use, about three 1-litre bottles of water.

Larger area, stronger grip

The 114 mm diameter increases the contact area and spreads the suction force. Always clean and dry the surface and the underside of the cup before mounting, as dust, pores or moisture weaken the vacuum.

How the suction cup works

Pump repeatedly until the red line on the valve enters the pump. Two release tabs marked OPEN remove the mount. The manufacturer states a holding force of 60 kg horizontally and 40 kg vertically, but the recommended load of the assembly is only 3 kg.

Two ball heads in every direction

One locking knob releases both ball heads so you can set the angle and tighten the arm again. The top 1/4"-20 screw fits cameras and accessories with a standard thread.

Sliding NATO rail

The included 60 mm NATO rail screws onto the base and you slide the clamp with the arm along it without disassembling the assembly. Spring stops prevent accidental release and a hex wrench is included.

1/4" and 3/8" threads

The base has 1/4"-20 and 3/8"-16 threads for additional compatible arms, mounts or accessories. Always watch the total load of the assembly.

Everything in one bag

The suction cup, arm, NATO rail and wrench fit into the fabric drawstring bag. You carry the set together and protect the rubber surface from dirt.

Application scenes

Static shots, time-lapse, shots through glass and low camera positions on a smooth surface.

Safety while using

When mounting on a vehicle, always add a safety rope and observe the manufacturer limits: up to 80 km/h and a load of up to 0.5 kg.

What is in the box

Suction cup mount, ball head arm, NATO rail, hex wrench and storage bag.

Parameters

The base measures approximately 135 × 115 × 65 mm.

More information