Tilta Nucleus Nano Run/Stop Cable for Canon DSLR Mini-USB Port

The Tilta RS-WLC-T04-CND is a run/stop cable for the Nucleus Nano wireless lens control system: one end plugs into the R/S port of the Nucleus Nano motor (2.5 mm jack), the other into the camera's Canon DSLR remote port (mini-USB). It carries a single signal — start and stop recording — so the REC button on the Nucleus Nano hand wheel controls recording without touching the camera body.

The Tilta RS-WLC-T04-CND links the Nucleus Nano to the camera's Canon DSLR remote port (mini-USB) and gives the REC button on the Nucleus Nano hand wheel direct access to recording. Focus stays wireless, run/stop goes over the cable.

Run/stop between Nucleus Nano and Canon DSLR remote port

On the Nucleus Nano side sits a 2.5 mm jack for the motor's R/S port, on the camera side a mini-USB connector. The cable is made for the Canon DSLR remote port (mini-USB): Canon EOS 5D Mark II/III, 7D, 7D Mark II. Other camera ports are covered by siblings of the same range — pick them from the drop-down above the price.

Tilta run/stop cables

A run/stop cable carries a single signal: start and stop recording. One end sits in a Tilta handle with a REC button or in the Nucleus focus system, the other in the camera port that accepts remote triggering — LANC, RED SYNC or CTRL, mini-USB on Canon DSLRs, Sony Multi, Hirose, Fischer or ARRI EXT. The cable is chosen by the handle × camera pair; this is one of the range.