Tilta Magnetic Accessory Mounting Kit for DJI Osmo Pocket 4 - Titanium White

The Tilta Magnetic Accessory Mounting Kit for the DJI Osmo Pocket 3/4 in titanium white combines two parts: the low-profile Mini Accessory Mounting Expander and the articulated Magnetic Mounting Stand. The frame gives the camera a 1/4″-20 thread, a cold shoe, a GoPro mount and the DJI magnetic connector; the stand sticks it magnetically to metal or puts it on a desk with 270° and 180° of tilt. The kit weighs 90.9 g and is made of aluminium alloy and SUS304 stainless steel.

Four interfaces on one frame

The frame wraps around the camera body and adds a 1/4″-20 thread, a cold shoe, a GoPro-style mount and the DJI magnetic connector. You can therefore hang a microphone, a small light, a handle or a handlebar mount on the camera without needing the original DJI handle. The rig stays low-profile and light.

Two axes: 270° on top, 180° below

The stand has two joints. The top one tilts through 270°, the bottom one through 180°, so you can set the camera at almost any angle — from a shot just above the table to a top-down view. The joints tighten steplessly, so they hold anywhere between the end positions.

Holds on metal without a single screw

The base plate of the stand is magnetic, so you can stick the camera to a fridge, a metal shelf, a post or a car bonnet and the shot is set. Where there is no metal, the 1/4″-20 thread takes over — the stand screws onto a tripod, an arm or a clamp. A magnetic flat-head screwdriver is included.

Joystick, buttons and card stay reachable

The frame is shaped to the camera body, so it does not cover the joystick, the buttons, the memory card slot or the lanyard hole. You can swap the card without taking anything apart. Inside is a layer of high-density silicone padding that holds the frame with no play and protects the camera finish from scuffs.