MOVMAX 1" Ball Connector with 1/4" Thread

The Movmax 1″ ball connector with 1/4″ thread links a camera, monitor or other lightweight device to the Movmax telescopic rod system. The 1″ ball fits a double socket arm, the device mounts on the 1/4″-20 screw.

The Movmax 1″ ball connector with 1/4″ thread is an end fitting for the telescopic rod system used for filming inside a car. The 1″ ball clamps into a double socket arm, and the 1/4″-20 screw at the other end holds a camera, monitor or other lightweight accessory with a standard thread.

A 1/4″ thread on a 1″ ball

A 1″ ball on one side, a 1/4″-20 screw on the other – an end fitting for the Movmax double socket arm.

1″ ball1/4″-20 screwFor double socket armsMovmax 1+N system

The angle is set in the arm

The connector itself has no joint – the ball clamps into the arm socket, where you loosen the knob, aim the device and tighten it again to lock the position.

Standard 1/4″-20 thread

The screw fits the common tripod thread of cameras, monitors and other lightweight devices, so you can put gear on the rod even where Movmax has no dedicated holder.

One rod, different devices

Movmax 1″ ball connectors differ only in the interface at the other end: a NATO clamp, an action camera mount or a 1/4″ screw. Swap the fitting to change what the rod holds in your car.

1″ ball

Clamps into the Movmax double socket arm.

1/4″-20 screw

The standard tripod thread of cameras and accessories.

Camera or monitor

Mount lightweight devices with a 1/4″ thread.

For in-car filming

Part of the Movmax telescopic rod system.