Tilta HDMI Male to HDMI Male Cable (30cm)

The Tilta TCB-MHD-MHD-30 is a 30 cm HDMI 2.0 cable with an HDMI plug at both ends. It carries 4K video at 60 fps from the camera to a monitor or external recorder, its diameter of only 3.6 mm makes it flexible enough to route along the cage, and it fits the Tilta cable clamps that often come with the cages.

The Tilta TCB-MHD-MHD-30 is a thin HDMI cable for the rig: 30 cm from the camera to a monitor on the cage, full HDMI 2.0 for 4K 60p and a 3.6 mm diameter that can be routed along the cage without straining the camera's connector.

HDMI 2.0, 4K 60p and a 3.6 mm diameter

The cable has an HDMI plug (type A) at both ends and carries an HDMI 2.0 signal, i.e. 4K video at 60 fps to a monitor or external recorder. The conductors are oxygen-free copper, the jacket PVC, and the cable diameter is 3.6 mm — thinner than a standard HDMI cable, so it bends around the cage without levering on the camera port and leaves no thick loop behind. The 30 cm length reaches from the camera's HDMI output to a monitor on the top handle or on the side of the cage.

Into Tilta cable clamps

The cable fits the HDMI cable clamps that Tilta includes with its cages: the clamp holds the cable to the cage body and takes the pull before it reaches the camera port. For a monitor further from the camera — on an arm or on the rods — the same cable comes in 60 cm (TCB-MHD-MHD-60).

Tilta cables

The Tilta TCB cable range links camera, battery and accessories on the rig: power from a V-Mount or Gold Mount plate over P-Tap, 2-pin Lemo, 3-pin Fischer or a DC barrel connector, USB-C PD for monitors and handles, 7-pin control cables for the Nucleus system and HDMI or BNC for the picture. Lengths follow the rig — short on the cage, longer out to arms and batteries; this cable is one of them.