The Tilta TCB-RBNC-RBNC-55 is a 20-inch (50.8 cm) SDI cable with a right-angle BNC plug at both ends. It carries the video signal from the camera's SDI output to a monitor or wireless transmitter; the BNC bayonet locks and does not pull out while working, and the right-angle connectors keep the cable close to the camera body and reach even an SDI port shadowed…
The Tilta TCB-RBNC-RBNC-55 is a 20-inch (50.8 cm) SDI cable with a right-angle BNC plug at both ends. It carries the video signal from the camera's SDI output to a monitor or wireless transmitter; the BNC bayonet locks and does not pull out while working, and the right-angle connectors keep the cable close to the camera body and reach even an SDI port shadowed by a large battery — as on the RED Komodo.
The Tilta TCB-RBNC-RBNC-55 is an SDI cable for the rig: a BNC bayonet that, unlike HDMI, locks and holds, right-angle connectors that do not stick out from the body, and 20 inches of length for a monitor on the cage or a transmitter on the rods.
Both ends carry a right-angle BNC plug with a bayonet lock: once inserted it is turned and holds, so the connection does not come apart during the shoot. The right-angle design runs the cable along the camera body straight from the connector rather than out at a right angle — it takes less room on the cage and fits even where the SDI port sits tight against a large battery and a straight BNC would not go in, as on the RED Komodo. The connectors are stainless steel, the conductors copper, the jacket black.
The 20-inch (50.8 cm) length reaches from the camera's SDI output to a monitor on the top handle or an arm and to a wireless transmitter at the back of the cage or on the rods without leaving a long loop. The cable suits any device with an SDI port on BNC — camera, monitor, transmitter and recorder. For the shorter run right on the cage the same cable comes in 30 cm (TCB-RBNC-RBNC-30).
The Tilta TCB cable range links camera, battery and accessories on the rig: power from a V-Mount or Gold Mount plate over P-Tap, 2-pin Lemo, 3-pin Fischer or a DC barrel connector, USB-C PD for monitors and handles, 7-pin control cables for the Nucleus system and HDMI or BNC for the picture. Lengths follow the rig — short on the cage, longer out to arms and batteries; this cable is one of them.
| Manufacturer: | Tilta |
| Category: | SDI cables |
| Cable type | SDI |
| Length | 0.5m |
| Connector type | BNC to BNC |
| Male / Female | Male - Male |
| Colour | Black |
| Connector shape | Right-angle |
| Konektory | BNC |
Special offers and discounts for subscribers only · Free audio & video workshops · News and tips from the world of filmmaking