Teradek RT MK3.1 Camera Control Cable pro RED DSMC2 (60 cm)

The Teradek RT MK3.1 Camera Control Cable 11‑1396 is a 60-cm cable for controlling a RED DSMC2 camera from a Teradek RT MK3.1 receiver. It connects the MK3.1 Receiver port to the SYNC connector on the RED DSMC2 camera and enables the run/stop function for compatible RED EPIC DSMC2 configurations.

The cable features Hirose → LEMO 00B connectors. For the RED DSMC2 Base Expander, the manufacturer specifies an older trigger protocol that requires a different MK3.1 DSMC cable; therefore, verify the specific I/O module of your camera before purchasing.

Run/Stop for RED DSMC2 and MK3.1

Model 11‑1396 connects the Teradek RT MK3.1 receiver to the SYNC port of a RED DSMC2-compatible camera. It enables run/stop control for RED EPIC DSMC2 setups, where a precisely matched camera interface is essential.

The 60-centimeter cable uses a Hirose connector on the MK3.1 side and a LEMO 00B connector on the camera side. This is not a universal control cable for all RED generations.

Verify the camera’s I/O module

For the RED DSMC2 Base Expander, the manufacturer specifies an older trigger protocol; a different MK3.1 DSMC cable is required for this specific configuration. Before connecting, check both the camera model and the installed I/O module.