MOVMAX Grip Dolly Middle Support

The Movmax Grip Dolly Middle Support is the centre support for the Grip Dolly camera dolly track. The cross bar keeps both Φ48 tubes parallel and its spigot sits on a stand or low stand, so a long track does not sag in the middle.

The Grip Dolly track is made of two round Φ48 tubes. The middle support holds them at a fixed spacing in the centre and transfers their weight, plus that of the dolly and camera, to the stand below. Side supports do the job at the track ends.

Middle track support

A cross bar that holds both Φ48 tubes of the Grip Dolly track in the middle and sits on a stand.

Middle supportΦ48 tubesStand spigotPart of Pro Kit

A track that does not sag

A long tube track bends in the middle under the weight of the dolly and camera. The middle support props it up at that point so the move stays level.

From the Grip Dolly Pro Kit

The same part comes in the Grip Dolly Pro Kit. On its own it replaces a lost piece or completes the kit of a bare dolly.

A genuine Grip Dolly part

Parts from the dolly maker fit the frame and the Φ48 tube track exactly, so you complete or repair the rig without improvising on set.

Fixed spacing

Keeps both tubes parallel at the dolly’s wheel gauge.

Stand spigot

The bottom spigot sits on a stand or low stand.

Genuine Movmax

Made for the Grip Dolly and its Φ48 tube track.

A 90 kg payload dolly

The part completes a dolly built for full cinema cameras.